Corghi EXACT 7000 Manual De Uso página 75

(10) Rear axle measurement (Fig.41)
To access this function from the rest of the pro-
gram select the
Level the sensors and adjust the angles by bring-
ing the values within the tolerance range (numeri-
cal data and graph bar coloured green).
The 2 rear axle measurement screens display
the rear camber angle, rear half-toe, rear total
toe, thrust angle, rear set-back and track differ-
ence values.
In the front axle measurement screen,
switches between the two pages of values.
returns to normal display mode.
(11) Front axle measurement
(Fig.23)
To access this function from the rest of the pro-
gram select the
Level the sensors and adjust the angles by bring-
ing the values within the tolerance range (numeri-
cal data and graph bar coloured green).
The 2 front axle measurement screens display
the front caster, front camber, front half toe, front
total toe and front set-back angle values.
In the front axle measurement screen
switches between the two pages of values.
returns to normal display mode.
For adjustment of the caster the data, only avail-
able if the steering lock measurement procedure
has been carried out, must be on the screen.
The data are only shown when the front sensors
are levelled.
N.B. On exit from this procedure the caster values
are saved automatically.
Saving of these values means that the procedure
can always be restarted from the last adjust-
ment made.
If a new steering lock procedure is performed, the
values recalled will be the last ones measured
during the steering lock sequence.
Operator's Manual EXACT 7000
icon or the F2 key.
icon or the F1 key.
(12) second angle measurement
with steering locked
Repetition of the steering axle angle measure-
ment allows you to check whether errors have
been introduced during adjustment of the
caster.
The procedure is exactly the same as the first
time the caster, king pin and steering angle dif-
ference values were measured.
Performing the steering lock procedure or
moves the program straight on to front
axle measurement.
(13) second front axle
measurement
Repetition of the front axle measurement proce-
dure allows any corrections to the adjustments
already made.
(14) Printout of the data measured
(Fig.42)
To access this function from the rest of the pro-
gram select the
The printout serves to inform the customer about
the operations performed and as a reference for
subsequent checks on the vehicle.
Fill in the heading of the job record
and print and/or save the job done using the
appropriate commands.
When the printout is complete, end the job and
return to the main menu
job for any further adjustments.
(15) Graphic printouts
The current printed report, supplied in alpha-
numeric form, has now been updated with the
addition of two annexes consisting of graphics
which illustrate some information about the
vehicle in intuitive form.
The first annex, entitled "Vehicle Condition",
shows the toe, camber and set-back values before
and after adjustment.
icon or the F4 key.
or restart the
75
GB