Corghi EXACT 7000 Manual De Uso página 70

displays the vehicle descriptions sup-
plied by the manufacturers for wheel alignment
operations.
displays the commercial descriptions
of the vehicles.
accesses compilation of the job
record.
If the user setup field "Alignment procedure
customisation / vehicle selection mode" = "Job
record" the data input form will be displayed.
Selection of the vehicle from the databank can
be selected from the record.
Different job record options are available in the
setup, "Job record / type" field.
Key to Databank abbreviations
/ Separates different models
4WD - 4x4 Four Wheel Drive
4WS Four wheel steering
ALU Lightweight alloy wheels
DR Door
CAB Enclosed light commercial ve-
hicle
CABR. Convertible
ESTATE - SW Estate Version (Station Wagon)
HD Heavy Duty or all-terrain
S Special or Sport
PAS Power Assisted Steering
LHD Left Hand Drive
RHD Right hand drive
FWD Front Wheel Drive
RWD Rear Wheel Drive
AS Pneumatic suspension system
HS Hydraulic suspension system
SLS Self-levelling suspension sys-
tem
RS Rigid suspension system
T Turbo
TD Turbo diesel
TDI Turbo Diesel Injection
R - RT Radial Tyre
XP Conventional Type Tyre
IFS Independent front suspen-
sions
IRS Independent rear suspensions
SPS Sports suspensions
LWB Long wheel base
MWB Medium wheel base
SWB Short wheel base
70
MM/AA+ After the indicated date (month/
year)
MM/AA- Before the indicated date
(month/year)
8565050+ From this chassis number
8565050- Up to this chassis number
AT Automatic Transmission
TA Twin axle
TS Single axle
LOA Loaded
PLO Partially loaded
UNL Unladen
AB Anti-roll bar
(4) Preparation for wheel
alignment
Information for preparing the vehicle for checking
and adjustment of its wheel alignment in accord-
ance with the manufacturer's instructions. The
program step is automatically activated if this
information is in the databank.
(5) Diameter input (Fig.35)
To access this function from the rest of the pro-
gram select the
The step is only active if it is set in the setup or
operation with toe values in units of length has
been selected.
Set the rim diameter of reference to work with
toe values in millimetres or inches.
reference rim diameter stated in data-
bank rim diameter set by the operator.
and
values in a preset list.
to do the job in angle measurements.
The angle unit of measurement selected in the
setup will be set.
(6) RoC (Fig.36)
Runout compensation or ROC is used to com-
pensate any geometrical errors in the rim (runout
and plane error) and errors in fitting the clamps.
The compensation skip option is available if set
in the setup.
Apply ballast to the vehicle as instructed and
select the RUNOUT compensation method
required.
Operator's Manual EXACT 7000
icon or the F10 key.
scroll through the diameter