Crystal Rf Module; Switching On With The 14.6. Hfm-S Synthesizer Rf Module; Switching On Without Transmitting An Rf Signal; Security Query At Power-On - Multiplex ROYALevo 7 Manual De Instrucciones

ROYAL evo 7
10.3.1. Switching on with the HFM-4 crystal RF
module
The power-on info display (
status display you last used (
order, the crystal RF module is activated and the trans-
mitter immediately radiates an RF (Radio Frequency)
signal. The LED starts flashing (
switches to the last active status display; the transmitter
is now ready for use.
10.3.2. Switching on with the HFM-S Synthesizer
RF module
The power-on info display (
by a screen showing the set channel and the associated
transmission frequency:
This in turn is followed by the status display you last
used. If everything is in order, the Synthesizer RF mod-
ule is activated, and the transmitter immediately radi-
ates an RF (Radio Frequency) signal. The LED starts to
flash ( 10.6.), the screen switches to the last active
status display, and the transmitter is ready for use.
The first time you switch on the transmitter with a Syn-
thesizer RF module, or if you replace the Synthesizer RF
module, the power-on info screen is followed by infor-
mation on how to set the transmission channel:
The method of selecting a channel using the HFM-S
Synthesizer RF module is described in the section
"Transmission channel selection with the HFM-S Syn-
thesizer RF module" ( 10.5.).
10.3.3. Switching on without transmitting an RF sig-
nal
It is possible to switch on the transmitter without radiat-
ing an RF signal, whether the unit is fitted with the HFM-
4 crystal RF module or the HFM-S Synthesizer RF mod-
ule. This means that no frequency channel is used, and
the transmitter can be operated for a long period for
programming (approx. 10 x longer than when the RF
module is operating).
Hold the tool button "L" pressed in as you switch on
you are now at the power-on menu,
RF stays OFF RF status LED (
stantly.
10.2.) is followed by the
10.7.). If everything is in
10.6.), and the screen
10.2.) is followed briefly
10.6.) glows con-
Page 18
One of the following displays appears:
With HFM-4 crystal
RF module
You can return to the last active status display by press-
ing any direct access menu button (one of the buttons
in the top row of the keypad) or the "ENTER" button.
!
Note:
The RF module remains switched OFF until you switch
the transmitter on again.

10.4. Security query at power-on

10.4.1.

Throttle check

If the parameter Thr. check is set to ON in the menu
L Transmitter (
13.1.5.), the following display
may appear when you switch the transmitter on:
The transmitter is immediately ready for use; an RF sig-
nal is transmitted.
!
However, for safety reasons the throttle channel is
held at idle until the throttle control (heli: throttle
limiter) is moved to the idle position (heli: to throt-
tle minimum).
The symbol under the message indicates the control
which operates the throttle. In the example above this is
the throttle stick. As soon as you move the throttle stick
to the idle position, the last used status display appears.
If you wish, you can switch the "Throttle Check" safety
query ON or OFF ( 13.1.5.).
TIP:
If the throttle check display does not disappear:
This can only occur if the throttle control is faulty, you
have operated the wrong control, or you have moved it
to the wrong end-point. You can by-pass the safety
query at any time by pressing any direct access menu
button or the "ENTER" button.
With HFM-S Synthesizer
RF module