Sub-Menu: Properties; Parameter: Template; Parameter: Mode; Parameter: Assignment - Multiplex ROYALevo 7 Manual De Instrucciones

The active flight phase is marked x . Only the active
flight phase can be copied. The following steps are nec-
essary:
Select the active phase ( x ) using the UP / DOWN
1.
buttons (L / M ), or use one of the two 3D digi-
adjustors.
2. Press the 3D digi-adjustor (or ENTER) twice;
the cursor jumps to the " x ".
3. Select the destination phase for the copy using the
UP / DOWN buttons (L / M ) or one of the two 3D
digi-adjustors;
the " x " changes to a " c " = copy.
5. Press the ENTER button or one of the 3D digi-
adjustors to conclude the copy process.

18.5. Sub-menu: Properties

The Properties sub-menu is a dynamic menu. The dis-
play may look as shown below, depending on the
model type (fixed-wing or helicopter) of the active
memory:

Parameter: Template

18.5.1.
Fixed-wing models and helicopters
Information field; cannot be changed
This parameter indicates which model template was
used to set up the current model (
only for the user's information, and cannot be changed.

Parameter: Mode

18.5.2.
Fixed-wing models and helicopters
Parameter affects the active model
I
only
Adjust. range Mode 1 ... Mode 4
The mode (stick mode) parameter is used to define
which stick controls which function in the model. The
mode can be changed at any time either here or in the
Setup / Control menu ( 13.3.1.).
18.5.3.
This parameter shows the assignment (which transmit-
ter control operates which function) with which the cur-
rent model was set up. The field only provides informa-
tion to the user, and cannot be changed.
18.5.4.
I
Adjust. range
Here you can determine whether your current model
helicopter requires a throttle curve to control the throt-
tle function, or whether fixed values are to be used (e.g.
electric helicopters with brushless motor in "regulator"
mode) (
18.5.5.
I
The menu point "Shift Switch" only appears if you are
using the US/ES language set. When other makes of
receiver are used it is sometimes necessary to adjust
Shift to suit the receiver:
+
-
!
18.6.2.). The field is
If you intend using the system with components made
by a variety of manufacturers, please note that careful
testing is essential. It is not possible for MULTIPLEX
Modellsport GmbH to guarantee that its systems will
function perfectly with products made by other com-
panies.
18.5.6.
I
This is where you can enter a name for your model; the
name can be up to 16 characters long. When you set up
a new model, it is initially assigned the name of the
model template you have used. The text for the name is
entered using the keypad; the procedure is described in
Section 11.1.3.
Page 51
ROYAL evo 7 - Instructions

Parameter: Assignment

Fixed-wing models and helicopters
Information field; cannot be changed

Parameter: Throttle curve

Model helicopters only
The parameter affects the active
model only
ON, OFF
14.1.11.).

Parameter: Shift

For US/ES language set only, with
, US/ES
fixed-wing models and helicopters
Parameter affects the active model
only
= Positive shift
= Negative shift
Note:

Parameter: Name

Fixed-wing models and helicopters
Parameter affects the active model
only