Main Menu Memory I; Sub-Menu: Select Model (Switch Memories); Sub-Menu: Copy; Sub-Menu: Erase - Multiplex ROYALevo 7 Manual De Instrucciones

Main Menu Memory I

18.
The ROYALevo7 has 15 model memories, numbered se-
quentially. You can assign a name up to 16 characters
long to each model memory.
The model data is stored in non-volatile memory, and
therefore cannot be lost even if you disconnect the
transmitter battery from the transmitter.
In addition to memory management (switching, copy-
ing, erasing), you can also set up new models (
and manage flight phases (
18.1. Sub-menu: Select model
(switch memories)
When you move to the Select model menu, you will
see a list of all 15 model memories:
The active model memory is marked x .
Empty model memories have no model name:
" -------- ".
It is possible to select an empty memory, but not acti-
vate it.
To switch models, select the appropriate memory using
the UP / DOWN buttons (
digi-adjustors, then press the ENTER button or one of
the 3D digi-adjustors. The screen then switches to the
last used status display. The transmitter is immediately
ready for use, and the model can be flown.

18.2. Sub-menu: Copy

Making a copy of one model memory can be a useful
time-saver if, for example, you wish to set up a new
model which is similar to one you already own, or if you
want to make experimental changes to the settings of a
model without losing the existing settings. The copy
process copies all the settings for the transmitter con-
trols, mixers, servos, timers, model name and trims.
There are four steps to copying a model memory:
1. Select the model
Select the model which is to be copied using the UP
/ DOWN buttons ( /
adjustors.
18.6.)
18.4.) in this menu.
/ ) or one of the two 3D
), or one of the two 3D digi-
ROYAL evo 7 - Instructions
2. Confirm your selection
Press the ENTER button or one of the 3D digi-
adjustors.
The letter "c" (= copy) now appears after the
model name (Fig. 1).
3. Define the destination
Select a target memory for the copy using the UP /
DOWN buttons (
adjustors. The model name of the model to be cop-
ied and the "c" go with you on the search (Fig. 2).
4. Confirm the destination
Press the ENTER button or one of the 3D digi-
adjustors.
Fig. 1
If the destination memory is empty, the copy is cre-
ated immediately.
If the destination memory is already occupied, the
security query appears: "Overwrite existing model?".
At this point you can interrupt the copy process by
pressing the ENTER button or one of the 3D digi-
adjustors.
If you wish to overwrite the existing model, press
the REV/CLR button.
After the copy process the previously active model is
called up again.

18.3. Sub-menu: Erase

If you wish to erase a model memory, first select the
memory, then press the ENTER button or one of the 3D
digi-adjustors. A security query now appears:
If you wish to erase it,
press the REV/CLR button to confirm your action;
If you do not wish to erase it,
press the ENTER button or a 3D digi-adjustor.
Erasing is not possible if you have selected the mem-
ory marked x , as this memory is currently active.
Page 49
/ ) or one of the two 3D digi-
Fig. 2