Working With The Keypad And 3D Digi- Adjustors - The Operating Philosophy; How To Call Up The Main Menus; How To Open Sub-Menus - Multiplex ROYALevo 7 Manual De Instrucciones

What can be assigned?
Virtually all parameters with numeric values can be as-
signed to a 3D digi-adjustor in this way, but there are a
few exceptions. In the following screen shot the "Step"
parameter (trim increment) cannot be assigned.
Assignable parameters with numeric values are indi-
cated by a vertical hyphen after the parameter name. If
you attempt to assign a parameter which is non-
assignable, this symbol appears when you press the
digi-adjustor assign button:
ƒ
You will also hear an error tone when you press one of
the 3D digi-adjustors.
Erasing the assignment (sequence only)
This is the procedure for erasing the assignment:
1. Hold the corresponding 3D digi-adjustor pressed in;
2. Press the (REV/CLR) button.
the screen displays "- - -", and the assignment is
erased.
Alternatively you can at any time "over-write" an as-
signment by assigning a new parameter.
Note:
To avoid the danger of making an accidental mistake,
assigned parameters cannot be reversed, i.e. it is not
possible to adjust a value past "0" or "OFF".
Note: (sequence only)
If you are using flight phase switching
Adjustment parameters which have different values in
different flight phases are displayed according to the
currently active flight phase, and can be adjusted inde-
pendently of each other from one flight phase to the
next using the appropriate 3D digi-adjustor.
ROYAL evo 7 - Instructions
11.3. Working with the keypad and 3D
digi-adjustors - the operating phi-
losophy
The method of switching the transmitter on has already
been described, as have the status displays (
10.7.).
The following section explains the operating philoso-
phy of the ROYALevo7 and the method of working with
the keypad and the 3D digi-adjustors, based on the ex-
ample of entering the user's name. The starting point is
one of the status displays 1 - 3 (
11.3.1.

How to call up the main menus

The direct access menu buttons are the key to entering
the transmitter's menu level for programming (
11.1.1.). In all six main menus are present, which contain
the following sub-menus:
L
SETUP (Configuration)
H
TRANSMITTER CONTROLS
G
MIXER
K
SERVO
A
TIMER (Stopwatch)
I
MEMORY
To call up a main menu simply press the corresponding
direct access menu button.
(Example: "Input owner's name": button L )
The following display appears:
The first line indicates the main menu in which you are
currently working (example: Setup main menu: "L
Setup").
The second line always shows "¨
( 11.3.4.) for more details.
The following lines list the associated sub-menus. The
four dots after the name of the sub-menu "...." indi-
cate the presence of additional menus (sub-menus).
11.3.2.

How to open sub-menus

You can select one of the sub-menus line by line using
the UP / DOWN buttons (
digi-adjustors. In each case the selected line is shown in
inverse video (dark background). This is similar to the
cursor on a PC.
(Example: "Enter owner's name": select the sub-menu
"User").
Page 23
10.3. /
10.7.).
Exit". See:
/ ) or one of the two 3D