Controlling Remote Video Accessories; Using The Sfb Serial Interface; Using The Dvi Fiber Outputs - Stryker 1288010000 Manual Del Usuario

Controlling Remote Video Accessories

The 1288HD Camera can remotely control up to two video accessories (such as the SDC Ultra, a
VCR, or a photo printer), enabling the user to capture images or start and stop video recording by
pressing the P button. (See also the "Using the Camera Buttons" section of this manual.)
1. Connect the video accessory to one of the remote outputs on the rear console panel. Use the
provided remote cables. (See Wiring Diagram 2 in the "Setting Up the Console" section of this
manual.)
2. Press the P button for less than one second to select Remote 1. One beep will sound.
3. Press the P button for more than one second to select Remote 2. Two beeps will sound.

Using the SFB Serial Interface

The SFB serial connection on the console rear panel enables FireWire connection to the Stryker
Endoscopy Software Management Site (SMS). Connect to the L9000 Light Source for "Run/Standby"
controls from the Camera Head.
Note: This system feature is not necessary for regular camera system operation.
This system feature requires an additional device (that is, a computer) to connect to SMS.

Using the DVI Fiber Outputs

Using controls or adjustments or performing procedures differently than
specified in this manual may result in hazardous radiation exposure.
The 1288 HD Camera has the optional upgrade, the fiber output, for model 1288010001. This
upgrade contains four laser diodes to transmit a DVI output over fiberoptic cables.
1. Connect four individual fibers (terminated in Lucent connectors) to the red (R), green (G), blue
(B) and clock (C) laser diodes on the console rear panel.
2. Connect the four fibers to a compatible fiberoptic DVI receiver.
• The four fibers should be connected to the camera console in the labeled order: RGBC
• The fibers should be connected to the monitor in one of two configurations: CBGR (reverse
order) or BGRC (R/B switched).
3. Ensure the fiberoptic output is enabled (on) via the Options Submenu in the Configuration
Menu. (See the section "Using the Configuration Menu".)
Note: The 1288 HD Camera model 1288010001 is a Class 1 laser product per IEC 60825-1 and
21CFR.
26