2. Clamping the wheel to the turntable (flg. 15)
- Fit the clamping device into the drop centre of the wheel (A).
- Turn the device for correct engagement with the turntable (B).
- By hand, move the centring cone into po¬sition on the rim by moving the retainers 1 (C).
- Tighten the clamping device by turning the handles 2 clockwise (D).
3. Tyre deflation (fig. 16)
- Operate the valve and fully deflate the tyre.
4. Bead breaker positioning (fig. 17-17a)
- Move the bead breaking unit from the its rest to its operating position
- Move the disc towards the rim:
- the horizontal movement is achieved by hand, rotating the console
- the vertical movement is achieved by operating control 21
- Once the desired distance is reached (a gap of 2-3 mm should be left between the edge of the rim and the bead
breaker disc), operate the (control 24) to inhibit any further horizontal movement.
NB
Before starting the demounting operation, make sure the machine is set with the column tilted from the
rear and the dual-position bead breaker support is not locked.
( Fig. 16 )
( Fig. 17 )
AE1032H
68
- 03 -
EN
DE
RU
KO
PT
( Fig. 17a )
JA
ES