SATA AE1032H Manual De Instrucciones página 73

CAUTION
When mounting a new tyre, replace the inner tube in
tube type tyres and the valve in tubeless types.
CAUTION
Always check that the tyre/rim combination is correct in
terms of compatibility (tubeless tyre on tubeless rim; tube
type tyre on tube type rim) and geometrical size (keying
diameter, cross-section width, Off-Set and shoulder
profile) before mounting.
Also check that rims are not deformed, that their fixing
holes have not become oval, that they are not scaled or
rusty and that they do not have sharp burrs on the valve
holes. Check that the tyre is in good condition with no
signs of damage.
Mounting the tyre
1. Tyre preparation (fig. 25)
- Grease both the tyre (A) beads.
-Place the tyre on the rim (B)
2. Head positioning (fig. 25a)
- Operate pedal (13) to move the head into the working position.
NB
The tool is already in the correct position for
mounting the tyre, unless the type of rim has been
changed.
3. Lower bead mounting (fig. 26)
- Place the bottom bead of the tyre under-neath the tool and at
the same time apply a little pressure to the tyre by hand while
starting to rotate the wheel (pedal 15) for easier bead insertion.
- Rotate until tyre mounting is complete.
4. Upper bead positioning (fig. 27)
- Position the upper tyre bead.
AE1032H
73
- 03 -
EN DE RU KO PT
( Fig. 25 )
( Fig. 25a )
( Fig. 26 )
JA ES