SATA AE1032H Manual De Instrucciones página 80

- From the position of the centring ridges check that the beads
are properly posi¬tioned on the rim; otherwise, deflate the tyre,
break the beads as described in the relevant section, lubricate
and turn the tyre on the rim. Repeat the mounting operation
described previously and check again.
- Replace the internal mechanism of the valve.
- Bring the pressure to the operating value by pressing the
Inflation push-button 20 fig. 34.
- Fit the cap to the valve to protect its in¬ternal mechanism from
dust and ensure an airtight seal.
- Remove and unload the wheel as de¬scribed in steps 11-12 of
the "TYRE MOUNTING" section.
Inflating tube-type tyres
- Make sure that the wheel on which the tyre has been mounted
is firmly secured to the turntable using the centring handle 1 fig.
34. Also make sure that the tool-carrying head and the bead
breaking unit are well clear of the working area, if possible in a
rest position.
- Connect the Doyfe inflator chuck 22 fig. 34 on the air hose to the
air chamber valve stem, after removing the cap. Inflate the tyre
by pressing the corresponding Pedal 14 fig. 34 at short periods
of time.The inner tube gradually expands inside the tyre. As this
happens,
push in the innertube valve to let out the air left between the
tube and the tyre; this prevents deflation and any possible damage
to the tube.
- Inflate, taking utmost care that the pressu¬re shown on the
Pressure gauge display 17 fig. 34 NEVER exceeds the pressure
levels recommended by the tyre producer.
- Fit the cap to the valve to protect its in¬ternal mechanism from
dust and ensure an airtight seal.
- Remove and unload the wheel as de¬scribed in steps 11-12 of the
"TYRE MOUNTING" section.
AE1032H
80
- 03 -
EN DE RU KO PT
( Fig. 34 )
( Fig. 35 )
JA ES