Setting Up The Optional Barcode Scanner; Turning On The Device Power; Connecting The Device Power Cord - Medtronic autoLog IQ Manual Del Usuario

Size: 7 x 9 in (178 x 229 mm)
• Refer to institutional policies regarding the handling of protected health information and data security before storing the device.
• Store the USB flash drive in a secure location.

10 Setting up the optional barcode scanner

The barcode scanner (sold separately) can be used to enter the following information into the device:
• Patient and operator IDs
• Blood collection and processing disposables lot data
• Heparin lot data
• ACD-A lot data
To set up the barcode scanner, perform the following steps:
1. To install the holster, use the tool included in the barcode scanner kit to remove the screw from the left side of the device
(Figure 8).
2. Attach the holster to the left side of the device, and then reinstall the screw using the tool.
3. Place the scanner in the holster, in an upright position.
4. Connect the scanner cord to a USB port (type A). See Figure 8.
5. Secure the cord using the barcode scanner cord retainer clip.
6. To scan data into the device, see Section 13.2.

11 Turning on the device power

11.1 Connecting the device power cord

1. Remove the power cord retainer clip (Figure 6) using the thumbscrew (Figure 12).
2. Insert the connector end of the power cord into the device power inlet module, and then insert the cord into the retainer clip.
3. Reinstall the power cord retainer clip using the thumbscrew.
Figure 12. Installing the power cord retainer clip and power cord
Warning: The power cord may be used to disconnect the device from electrical power. Position the device and power cord so
that the power cord can easily be accessed and disconnected.
4. Insert the plug end of the power cord into a grounded, hospital-grade supply mains.
11.2 Turning on the device power
1. Press to turn on the device. The power LED illuminates, the alert light flashes, and the speaker emits 2 beeps.
Note: Press
the Settings screen (Figure 14).
Figure 13. Turning on the power to the device
2. If turning on power for the first time, select the desired language.
3. Set the password if desired.
English
M967226A006 1B Medtronic Confidential
to activate the vacuum at the default setting, during startup. The default vacuum setting can be changed using
20
502431-132
Composed: 2018-06-08 06:06:55
PSJ - Size-selectable package manual 02-MAY-2018