Publicidad
User Manual
Service
Troubleshooting
Error message
ERR: The computer receives no signal during the Recovery Program
or
the computer receives no signal during the BMI-Body Fat
Measurement test mode .
E1:
The computer receives no signal from the motor or the signal is
interrupted .
ERR2: There is no connection between the power board and the computer
or the power board is defective .
Solution: see "The computer display is not working" .
The computer display is not working
• The computer might not be getting power. Check all connections and
cables .
• If all connections are in order and you still have no read out on the display
please contact your local ENERGETICS-dealer .
Heart rate (PULSE) shows no or incorrect read out
• Check if your palms have proper contact with the sensors. Both palms have
to be in contact with the sensors simultaneously . The display may be on a
slight delay .
• Check all cable connections.
• Try moistening your hands if they are dry.
All manuals and user guides at all-guides.com
The computer has shut down
In rare cases the computer might shut down, mainly because of sudden
changes in the electrical current or static discharge . Normally the E-203
restarts on its own .
Should this not occur restart the computer by pulling the power plug, wait a
few seconds then reinsert it .
Care
Take care that to avoid any moisture penetration . Clean the computer with a
lightly dampened cloth . Do not use abrasive cleaning solutions .
Maintenance
There is no need for special maintenance . Regularly check that all bolts and
connections have a tight fit . Exchange any defective parts immediately . For
assistance contact your local ENERGETICS-dealer .
Publicidad
Capítulos
