Publicidad
Idiomas disponibles
Idiomas disponibles
3.6
Conformity-assessed Devices
Some settings of conformity-assessed models are protected against
operator changes, e.g. "external calibration". This measure is intended to
ensure the suitability of the devices for use in legal metrology.
3.7
Accessories
Accessories are available for the device. These enable the device to be
customized to the specific conditions during weighing procedures, e.g.
weighing pan, sample holder or internal draft shield.
3.8
Below-balance Weighing
The device is suitable for below-balance weighing. Samples can be
suspended for weighing using below-balance weighing, e.g. samples, which
do not fit on the weighing pan. Below-balance weighing is possible under
the following conditions:
— The device must be set up on a weighing table with recess.
— For below-balance weighing, a below-balance weighing hook must be
inserted in the device base (see Chapter "16 Accessories", page 88).
In legal metrology:
— The below-balance weighing equipment may not be used.
— The cover of the below-balance weighing equipment may not be
removed.
Operating Instructions Cubis
Device Description
| MCA Models
®
19
Publicidad
