Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1
44
Operating Instructions Cubis
5.5
Placing the Device on its Side and Installing
For some installation work, the device has to be placed on its side, for
example when inserting connection cables.
Material:
1 soft support base, for placing down the device
Requirement
— There are no components installed in the pan retainer.
— All outer draft shield doors are removed: Front panel, upper panel, side
panels.
CAUTION
Risk of injury when lifting or transporting!
Use both hands when transporting the device and setting it down. To do
t
this, reach sideways under the device with both hands in the rear part of
the device.
Procedure
Remove the operating display from the device.
t
If the device is to be placed on its side:
t
Reach sideways under the device with both hands in the rear part of
t
the device.
Turn the device on its side and place it on the soft support base.
t
If the device is to be returned to the upright position:
t
Reach sideways under the device with both hands in the rear part of
t
the device.
Place the device back onto its base.
t
5.6
Inserting the Connection Cable for the
Operating Display
Procedure
Place the device on its side (see Chapter 5.5, page 44).
t
Fully press the connection cable for the operating display into the cable
t
channel along the side of the device. The connection cable for the
operating display must not come into contact with the side panels as this
can cause device malfunctions.
Place the device back onto its base.
t
| MCA Models
®
Publicidad
