J.P. Bowlin Sartorius Cubis II Manual página 788

Cleaning and Maintenance
70 Operating Instructions Cubis
9.1.2 Removing the Weighing Pan and Associated
Components
Procedure
Open the draft shield, e.g. the right-hand door.
t
Remove the weighing pan and the associated components from the
t
device:
— Weighing pan (1)
— If there is a weighing pan with a shield plate: The shield plate (2)
— Base plate of weighing compartment (3)
1
2
3
9.2 Cleaning the Device
Sartorius recommends cleaning the device at regular intervals, e.g. weekly.
Do not allow deposits to form on the weighing pan.
To clean the device, you can use the cleaning utensils supplied or a damp
cloth, as well as the "Cleaning" QAPP.
Requirements
The device is ready for cleaning (see Chapter 9.1, page 69).
Procedure
WARNING Risk of injury due to electrical current! Protect the power
t
supply unit and the power supply cable from liquids.
Only use suitable cleaning agents and cleaning procedures and observe
t
the product information for the cleaning agent used (for cleaning
agents, see Chapter "15.14 Cleaning Agents and Cleaning Procedures",
page 85).
Dampen a cleaning cloth with the cleaning fluid and wipe the surfaces of
t
the device, e.g. the housing or the weighing compartment.
If required: Dry the surfaces with a non-abrasive cloth.
t
If the dirt is not coming away easily:
t
Lightly spray the surfaces of the device with the cleaning fluid.
t
Leave the cleaning fluid to work (for recommended contact time, see
t
Chapter "15.14 Cleaning Agents and Cleaning Procedures",
page 85).
Dry the surfaces with a non-abrasive cloth.
t
| MCA Models
®