J.P. Bowlin Sartorius Cubis II Manual página 787

9 Cleaning and Maintenance
9.1 Preparing the Device for Cleaning
Procedure
If an accessory is connected to the device: Disconnect the accessory
t
from the device (see instructions for the accessory).
If the upper or lower cover for the rear wall of the weighing compartment
t
is removed: Insert the cover for the weighing compartment into the rear
wall of the weighing compartment (see Chapter 6.5, page 49).
9.1.1 Dismantling the Draft Shield
Procedure
Remove the operating display from the device.
t
Pull off the front panel of the device upwards.
t
Remove the right and left doors. To do this, pull each door forwards to
t
pull it out of the guide rods on the device.
Pull the upper door forwards on both sides and remove it from the guide
t
rods on the device.
Operating Instructions Cubis
Cleaning and Maintenance
| MCA Models
®
69