/H Pump); Programming And Operation: Pump Oil Dehumidification Cycle - Orved Bright Serie Manual De Uso

9.9 PROGRAMMING AND OPERATION: PUMP FUNCTION
(MODElS WITh A ThREE-PhASE 60 AND 100 M
Read Chap. 5.2.6
The pump function enhances the performance of the high capacity pumps (60 and 100 m
vM1800N, vM30N models and is useful in cases when the machine is to be used continuously for at least 30 minutes.
1) Press the "PUMP" button for three seconds. The function is activated and the Pump is started-up.
"PUMP FUNCTION ON" appears on the display for a few seconds.
All the functions are set according to the saved program.
All the functions are performed normally, with the pump running continuously
2) Press the "PUMP" button again for three seconds to disable the function.
"PUMP FUNCTION OFF" appears on the display for a few seconds.
After 15 minutes of inactivity, the function is deactivated and the pump turns off.

9.10 PROGRAMMING AND OPERATION: PUMP OIl DEhUMIDIFICATION CyClE

Read Chapters 6.1 and 6.5.4 carefully
The cycle lasts 20 minutes and must be run weekly or more often in accordance with machine use.
1) Select the "h OUT" program. "h
2
2) lower the lid within 25 seconds following the activation. The cycle is activated. The LEDs indicate operation until
the total time of the cycle (20 minutes) elapses.
3) At the end of the cycle, the machine returns to idle mode. It is ready for a normal operation cycle according to the
set program.
4) Stopping the cycle in advance: the dehumidification cycle can be interrupted at any time
by pressing the "STOP" button.
Rev. 05 - 04/2018 - Cod. 1500458 - Instruction manual for vacuum chamber packaging machines with digital control panel "Serie Bright"
3
OUT READy" appears on the display.
2
/h PUMP)
OPERATION
/h) in the vM53h N/60, vM20N,
3
53