RayTek AUTOPRO Manual De Instrucciones página 8

LED Illumination
An LED is located on the front of the unit. When
the trigger is pulled, notice a bright LED illuminates
the area including and around the area being mea-
sured for convenience unless switched off.
Magnetic Base
A removable magnetic base is attached to the
bottom of unit, below the handle. The magnetic
base allows the unit to be attached to any ferrous
metal surface. The magnet's surface has been
engineered not to scratch finishes by recessing
the actual magnets. However, metal shavings
and debris can be inadvertently picked up by the
magnetic, and if not removed and cleaned, can
damage the finish of a surface. The magnetic base
is attached to the unit using a Phillips head screw
and can easily be removed using a screwdriver.
Reminders
n Not recommended for use when measuring
shiny or polished metal surfaces (stainless
steel, aluminum, etc.). See "Emissivity" for
measuring these surfaces.
n The unit cannot measure through transpar-
ent surfaces such as glass or plastic. It will
measure the surface temperature of these
materials instead.
n Steam, dust, smoke, or other particles can
prevent accurate measurement by obstructing
the unit's optics.
n The thermometer can be pointed using the
sighting guides on top of the unit whenever it is
difficult to see the laser sighting system.

Maintenance
Lens Cleaning: Blow off loose particles using clean
compressed air. Gently brush remaining debris
away with a soft brush. Carefully wipe the surface
with a moist cotton swab. The swab may be
moistened with water.
Note: Do not use solvents to clean
the plastic lens.
Cleaning the housing: Use soap and water on a
damp sponge or soft cloth.
Note: Do not submerge the unit in
water.
CE Certification
This instrument conforms to the following
standards:
n EN61326-1 EMC
n EN61010-1
n EN60825-1 Safety
Tests were conducted using a frequency range
of 80–1000 MHz with the instrument in three
orientations.
Note: Between 165 MHz and
880 MHz at 3V/m, the
instrument may not meet
its stated accuracy.