Hp33449Printer - HP LaserJet II Serie Manual De Instrucciones

HP 33440/HP 33449 COMBINED SERVICE MANUAL
HP 33449 Printer
It
is recommended that the four interlocking cover panels that form the HP 33449 Main Body
Covers be removed one at a time as described below (see Figure 6-7). Structural damage can occur
if the assembly is removed as a unit.
Caution
Since the printer's model and serial number are permanently attached to the Fan
@
Guide portion of the right side cover panel, be sure to put the panel back on the
printer from which it was removed. If the right side cover panel must be replaced,
the Fan Guide panel containing the model and serial number must be transferred
to the new right side cover panel.
1.
2.
3.
4.
5.
6.
Remove the power cord from the printer's receptacle.
To remove the top cover panel of the Main Body Covers, open the hinged Top Cover Assembly
and remove the screws (3) securing the top cover panel, then push in on the right side cover
panel
at
the points shown in Figure 6-7. Rotate the rear of the top cover panel to vertid before
lifilng it off.
Remove the right side cover panel by removing the screws (2) – one at the rear nefi to the
Power Switch and one attaching it to the front cover panel - and Ifilng it vertidly
out of the
printer. Note that the Fan Guide panel (Power Switch area) which contins the model and
serial number plate can be detached from the right side cover panel (see following).
Remove the lefi side cover panel by removing the screws (3) – MO attaching it to the base plate
and one attaching it to the front cover panel - and lifing it vertidly
out of the printer. Be
careful to keep the front cover panel from falling. (Hinti Leave the paper tray instiled to hold
the front cover panel in place.)
Detach the Control Panel Cable connector by pushing the plastic latches outward, then
unseating the connector.
Remove the front cover panel. Use caution to avoid damage to the Control Panel.
When replacing the front cover panel, its lower lip must slip under the plastic rim of the base
cover panel. The three tibs on the front edge of the top cover panel must fit into the slots on the
front cover panel before rotating the top cover panel into place (see Figure 6-8).
6-12