HP LaserJet II Serie Manual De Instrucciones página 153

HP 33440/HP 33449 COMBINED SERVICE MANUAL
TOP COVER ASSEMBLY REMOVAL
Two
methods are possible for removing the Top Cover Assembly Method One should be used if
the Hinge Assemblies or Hinge Bracket Plates (see Figure 6-39-and Figure 6-40) must be replaced;
Method Two should be used in dl other cases.
Method One:
1.
2.
3.
4.
Open the Top Cover Assembly and remove the
EP-S
Cartridge.
Remove the Hinge Security Plates (one screw on each hinge plate) and separate'the NO coil
springs on the left side (see Fi~re 6-39). Swing the Hinge Springs out of the way.
Remove the Hinge Bracket Plate screws (4 - two through each Hinge Bracket Plate) where
they attach to the Top Cover Assembly, supporting the Top Cover Assembly as you do so.
Separate the Top Cover Assembly from the Hinge Bracket Plates.
Scr&ws (2)
Hi;ge
Inside Hinge
Security Plate
Bracket Ptite
Figure 6-39. Top Cover Assembly Removal, Method One
6-44