HP 33440/HP
33449 COMBINED
SERVICE MANUAL
4-7. FUSER CLEANING PAD
REPLACEMENT
To replace the Fuser Cleaning Pad
1.
2.
3.
4.
5.
6.
7.
—
Open the Top Cover Assembly.
Open the Fusing Assembly top cover (green felt cover).
Remove etisting cleaning pad (see WARNING below).
Use the felt end of the new cleaning pad to wipe the Fusing Assembly roller.
Discard the felt end of the cleaning pad and insert the new cleaning pad.
Lower the Fusing Assembly cover (it does not close tightiy).
Close the printer's top cover and turn the printer ON.
Warning
The Fusing Roller gets HOT. Be sure to hold the Cleaning Pad by the green
@
tabs as shown in Figure 4-15.
Figure 4-f5.
Replacing the Cleaning Pad
4-14