HP LaserJet II Serie Manual De Instrucciones página 52

HP 33440/HP 33449 COMBINED SERVICE MANUAL
Table 3-1. Factory Default Settings (continued)
DTR Polari@ (DTRPOLARITY=)5 HI HI
RET (RET=)
n/a DARK
Page Protect (PAGEPROTECT=)6
n/a OFF
Display Language (LANGUAGE=)7
n/a ENG (Engtish)
Envelope Tray 8 E~LOP= COM1O PE TRAY= COMIO/DL3
1.
Ody
displayed when a salable, fried-spaced font is selected.
2. Only displayed when a salable, proportional-spaced font is selected.
3. Facto~-set with HP 33449AB (220 ~.
4. Only ~lsplayed if SERN is selected as the 1/0 interface.
5. Only displayed if SERN and RS-232 are selected.
6. Only available with added memory.
7. Refer to Appendix B for configuration instructions.
8. Only &splayed when the Envelope Tray is insetied.
Envelope Cassette Size Setting
Whenever an envelope tray is inserted in the printer, the Control Panel will display ENVELOPE=
(HP 33440) or PE TRAY= (HP 33449). The envelope tray was designed for a variety of envelope
sizes and the Control Panel setting establishes the printable area for four common sizes. These
are MONARCH, C5, DL, or COM1O. The first time an envelope tray is inserted in the printer,
this message will read ENVELOPE= COM1O* o r PE TRAY= COMIO*(the asterisk indicates the current
default choice). If an envelope size different from COM1O is being used, the Q and Q keys
should be used to display the available choices. When the [-j key is used to make the desired
selection, this choice becomes the new default value. This means that when an envelope tray is
insetied in the printer, the display will read from that time forward ENVELOPE/PE TRAY= [selected
choice] *.
For the HP 3W9 only, note that if an dternati selection is not made within 10 seconds tier
inserting the envelope tray, the printer @ return to an on-line condition using COM1O (or other
previously selected envelope size setting) as its expected envelope size. To alter this setting, the
envelope tray should be removed and reinstiled, and the selection procedure repeated within 10
seconds of reintilation. In contras~ the HP 33440 printer will remain in an off-line condition
until expficitiy placed on tine by the user after insertion of an envelope tray.
Keep in mind that this setting is completely independent of any Printing Menu item selection.
This means that for example, although the paper/envelope size in the Printing Menu of the HP
33449 may have been changed to ENVELOPE=C5, insertion of an envelope tray will yield the same
PE TRAY= [envelope size] message, where the displayed envelope size may not necessarily be c5. If
C5 envelopes are indeed loaded in the envelope tray, the user must notify the printer of this fact at
the time the tray is intiled. Once selected, however, mch subsequent time the envelope tray is
instied, PE TRAY=CS*(in our example) will be displayed as the new default value.
For both printers, once set, the envelope tray size setting will not be altered by any other
procedure than the one just discussed. Not even a COLD RESET routine will modify this setting.
3-12