HP LaserJet II Serie Manual De Instrucciones página 335

HP 33440/HP 33449 COMBINED SERVICE MANUAL
Set Up
to
Use
a Setial Intetiace
The following setup information applies to MS-DOS-based computers; Hewlett-
Packard has not tested other operating systems. If you have an operating system
other than MS-DOS, contact your computer dealer for information.
Use a screwdriver to attach serial
Install the intetiace card for your
cable.
computer, if required.*
Make sure both your computer and
printer are turned off, and then plug the
cable into your computer and your
printer. Use a small screwdriver to attach
the cable to the printer. Note into which
serial port on your computer (COM1 or
COM2) you plug the cabla you will need
this information later.
*H WU need a serial intetia~ for ~ur HP Ve@ra,order HP pm numbr HP2- or HP24WIA for the dual
sefial option. HWU have a differentw of mmputer, mntaat ~ur l-l deder for information.
IBM PC, PCm/PS 2
& IBM Compatibles
Compaq Portable
AT&T
HP Vectra
IBM PCIAT &
IBM Compatibles
Compaq Deskpro
266/366
HP Vectra
(Dual Serial Card)
m
'p'a'#
Length
m
9 Pin Female HP24542G 9.9' (3.0 m)
25 Hn Male
-
HP Part# Length
-
25 Pin Male HP17255M
3.9' (1.2 m)
25 Pin Male
HP13242~Ol O 16.7' {5.0 m)
Choose the right cable for your computer.
Now go
to
o
If you are going to use a serial RS422 cable, see AppendN E, "Interfaces," in the LaserJet series II User's Manual.
A-12