HP LaserJet II Serie Manual De Instrucciones página 363

HP 33440/HP 33449 COMBINED SERVICE MANUAL
j ~~~~~-~
~~=qg p(n,qpr>,
b i H& k)uknw
The following section describes procedures for the removal of two cover plates, insertion of the
board(s), and the replacement of the cover plates.
Unless otherwise note~ replacement is the
reverse of removal.
A screwdriver (flat-blade or Phillips) is needed.
?Nole
~rst, read all instructions caretily. Wke sure all procedures are
understood before be@nning installation
~,~
<>
1. Switch printer OFF and unplug power cord.
2. In order to remove the plastic W Expansion access cover on the printer's leti side base,
position the printer so that its left side overhangs a supporting surface by approximately one
inch (see Figure C-2).
flh
1" (25.4 mm)
!,17-F
dvdb
nir. a
The printer weighs over 50 pounds. If necessary, ask for assistance in moving
it about the work area.
~q~j,
(~~
3.
Remove the plastic W Expansion access cover by inserting the tip of your finger in the
slot under the center of the lower edge, then pulling the plate outward and downward (see
Figure C-2),
c-5