Registration Assembly - HP LaserJet II Serie Manual De Instrucciones

HP 33440/HP 33449 COMBINED SERVICE MANUAL
REGISTRATION ASSEMBLY
General
The Registration Assembly mn be removed tithout removing the DC Power Supply. When
replacing, the esape (drive) gear at the right end of the assembly must stide under the solenoid on
the Paper Control PCA. The DC Power Supply may need to be removed h do this.
Registration Assembly
Noie
Prior to removing the Registration Assembly, take mre to note the position of the
brass grounding blo& lomted at the lefi front end of the assembly in order to
replace it properly (see "Caution" below).
1. Open the Top Cover Assembly and dso remove the paper tray.
2. Remove the screws (2) securing the rear of the assembly and the screws (2) securing the
Transfer Guide Plate and the front of the assembly.
3. Lifi the Registration Assembly (see Figure 6-29) up and out.
When reinviting the Registration Assembly, ensure that the Transfer Corona Roller Grounding
Block is properly positioned (see following page).
A
*ew
Transfer
Corona Roller 'rew
AA] _=
.,
-,,1,
Transfer Guide
Figure 6-29. Registration Assembiy
6-34