HP LaserJet II Serie Manual De Instrucciones página 365

HP 33440/HP 33449 COMBINED SERVICE MANUAL
6.
To filly seat the board, hold the printer with your free hand, then
fimly
push against the
board's flat green plastic area (see Figure C-5).
7, If a second board is to be instiled, insert it into the empty slot in the same manner. Be sure
to
fimly
push against the green plastic area to properly seat the board's pin connector as
descfibed in step 6.
8.
—
To replace
the meti cover plate, first place the lefi slot behind the left screw, then tign the
center slot over the center screw and push in until the plate is flush with the base. Ne~ slide
the plate to the right as far as possible (until the right-most screw is engaged), and tighten the
three screws. Replace the plastic cover.
TEST INSTALLED BOARD
With the power switch OFF, plug in the power cord, then switch the printer ON. (Depending
upon the amount of in~led memory, the printer may take up to 55 seconds to reach on-line
status.)
Run a 05 SELFTESTby taking the printer off line, then holding down the
(PRINT FONTS/TESTj
key until
05
SELF TEST is
displayed (about three seconds). When the printing portion of the test
begins,
06
PRINTINGTESTwill be displayed. If the board is operating correctiy, the self-test
printout will show one of the w size messages in the Self-Test Message Table below.
SELF-TEST MESSAGE TABLE
.Fo~@ slot -Wr "slot W Size Mwwge
lM
None W size: 2048K bfles
t2
M INone IW size 3072K b~es I
lM lM W size 3072K b~es
2M
lM W size 4096K bfies
lM 2M M size: 4096K bvtes
I
I
"
2M ]2M ]W size: 5120K bfies
c-7