Getting Started; First-Time Setup - Ambu aBox 2 Instrucciones De Uso

Symbols for the
displaying unit

4. Getting Started

4.1. First-time setup

Follow the steps below before using the displaying unit for the first time. Letters in grey circles
refer to the illustrations in the Quick Guide on page 2.
1. Unpack the displaying unit and verify that no parts are missing. Refer to the parts
described in section 2.4.
2. Closely examine the displaying unit and other parts for any damage. Do not use the
displaying unit if it is damaged in any way A .
3. Place the displaying unit on a hard and leveled surface. Be aware to place the displaying
unit in a position where the power cord is accessible. The displaying unit can be placed on
a medical cart to make it moveable. Make sure to proper position of the displaying unit to
avoid falling down during transportation.
4. If necessary, connect the supplied Wi-Fi antenna to the back of the displaying unit.
5. Connect the power cable to a power outlet and insert the power plug into the power inlet
on the back of the displaying unit B .
6. If needed, connect an external monitor C and/or medical imaging recorder to the back of
the displaying unit.
7. If necessary, manually adjust the orientation of the touch screen of the displaying unit D
8. Turn ON the displaying unit by short pressing the power button. The indicator light in the
power button switches from orange (STANDBY mode) to green (ON) E , but a live image is
available soon after the monitor is turned on if a visualization device is connected. If no
visualization device is connected, the interface will illustrate how to correctly connect a
visualization device to the displaying unit.
9. Select the preferred language, then press
10. Select and confirm your country, then press Continue
11. Go to Appendix 3. Cybersecurity and ensure that the use of the displaying unit's software
and connectivity is aligned with your organization's policies.
12. Log in as Administrator to get access to system settings: Press the Login tab
in the Toolbar.
– Press arrow right
– Enter the password and press Log in
– Follow the instructions on the screen to change the password (required on first use).
Description
Humidity Limitation
Catalogue Number
4 , then press System Administrator
6
1
Symbols for the
displaying unit
1 .
. Press confirm
2
5 .
. The factory default password is AmbuAdmin
Description
Atmospheric
Pressure Limitation
3 .
2
13