Lan Connection Via Ethernet Cable; Set Up Static Ip Address And/Or Dns Server For A Wi-Fi Or Lan Network; Disconnect From Wi-Fi Network - Ambu aBox 2 Instrucciones De Uso

6.1.4.1. Import TLS certificates from a server
1) Ensure that the displaying unit is connected to a temporary Wi-Fi or LAN network
(see section 5.1.1 or 5.2.).
2) Press Server import.
3) Enter Certificate file name
4) Press Import 18
6.1.4.2. Import network certificates from a USB flash drive
1) Ensure that USB connection has been enabled for certificate import (see section 2.5.).
Insert USB containing network certificate. (see section 6.1.4).
2) Press USB import and wait while the displaying unit searches for network certificates on
the USB flash drive.
3) Select the required network certificate and press Import
Note: When the network certificate has been imported, the name of the certificate file is
shown below Imported Network certificates in the Network menu.

6.2. LAN connection via Ethernet cable

1) Connect a LAN cable to the Ethernet connection port on the back of the displaying unit
and to a router or LAN wall socket.
2) In the Network menu, check the LAN connection status shown below Ethernet.
6.3. Set up static IP address and/or
DNS server for a Wi-Fi or LAN network
1) In the Network menu, press the currently
selected Wi-Fi network.
2) Below the name of the Wi-Fi network, press the
arrow next to IP address. Press the ON/OFF
slider next to Enable static IP
manual DNS servers
enter the required information.

6.4. Disconnect from Wi-Fi network

In the Network menu, press the currently selected. Wi-Fi network, then press Disconnect.
18
, Host name
15
.
18
or Configure
20
(switch to green) and
21
, and Port number
16
15
16
.
19
19
.
17
17
20
21