Grundfos SE1 50 Instrucciones De Instalación Y Funcionamiento página 28

10.5.5 Shaft seal kit
Pos. Description
105 Cartridge shaft seal
110 x 3
107 O-ring 134.5 x 3
160 x 3
17.0 x 2.4
153b O-ring
28 x 2
157 Corrugated spring
For position numbers, see page 846.
A possible replacement of the cable must be carried
Note out by Grundfos or a service workshop authorized by
Grundfos.
For service parts not shown in the above table, consult
www.grundfos.com > WebCAPS > Service.
Examples of service parts:
• Cable
• pump housing
• impeller
• bearings
• shaft/rotor
• clamp
• stator
• motor complete, both standard and Ex.
10.6 Contaminated pumps
If a pump has been used for a liquid which is
injurious to health or toxic, the pump will be classified
Note
as contaminated.
If Grundfos is requested to service the pump, Grundfos must be
contacted with details about the pumped liquid, etc. before the
pump is returned for service. Otherwise Grundfos can refuse to
accept the pump for service.
Possible costs of returning the pump are to be paid by the
customer.
However, any application for service (no matter to whom it may
be made) must include details about the pumped liquid if the
pump has been used for liquids which are injurious to health or
toxic.
Before a pump is returned, it must be cleaned in the best possible
way before it is returned.
Service instruction and service video can be found on
www.grundfos.com.
28
2-pole:
4-pole:
Rubber type:
Kit no:
2.2 - 4.0 kW
1.1 - 2.2 kW
NBR
96102360
1
1
1
1
1
6.0 - 11 kW
3.0 - 7.5 kW
NBR
96102361
1
1
1
1
1