Blackmagic Design Cintel Manual De Instalación Y Funcionamiento página 24

NOTE When scanning interpositive and internegative film, the increased
density of the film requires slightly extended pulse durations from the light
source. Normally, this does not affect the scan, however, a slight reduction in
resolution may occur when scanning at above 12 frames per second. If you do
notice a difference in resolution, simply reduce your scanning speed to
12 frames per second or less.
Enable 2 Pass HDR Scan:
‚
standard scan.
Perf nudge: Used for making fine adjustments of the perf position relative to the
‚
scanner gate aperture. Command-J nudges up, while Command-L nudges down.
Frame: These buttons are push and hold to activate. When on, the film is slowly
‚
advanced to move the frame up or down and when released the film stops in
place. This is useful for aligning the film frame with the scanner's sensor. Using the
'perf nudge' and 'frame' buttons, you want to align the visible film frame so the bottom
of the previous frame and the top of the next frame are just visible at the top and
bottom of the viewer, and the current frame is centered vertically.
It's important to make sure the image in the viewer is not zoomed in when you do this.
Command-Left Arrow on your keyboard moves the frame up, while Command-Right
Arrow moves the frame down.
Scan Speed: With adequate disk performance, you should be able to scan at 30 fps.
‚
However, if you're scanning to a slow hard drive, you can reduce the scanning speed to
a frame rate that's suitable for your workstation without dropping frames.
Supply: Sets the wind direction of the left-hand side feed spool. While auto-detection
‚
will prevent incorrect operation, you should manually configure the reel winding
direction based on how each film roll is wound.
Take up: Sets the wind direction of the right-hand side take up spool. While
‚
autodetection will prevent incorrect operation, you should manually configure the reel
winding direction based on how each film roll is wound.
Use Film Reel: Small film reels have a different weight and inertia compared to large
‚
film spools, and this can affect the transport system. Tick this box to switch to settings
that offer improved stability for small film reels.
Focus Assist: Enables luminance peaking on your scanner's HDMI monitor output, plus
‚
the viewer inside DaVinci Resolve's film scanner panel, which makes it easy to obtain
optimum focus adjustments.
Sets the high intensity HDR scan to take place after the initial
Capturing from Cintel using DaVinci Resolve 24