Attaching The Audio And Keykode Reader - Blackmagic Design Cintel Manual De Instalación Y Funcionamiento

Attaching the Audio and KeyKode Reader

The reader is powered by your scanner's left options interface, which is the 6 pin accessory
XLR connector underneath the feeding spool.
To attach the Audio and KeyKode Reader to your Cintel Sanner:
1 First make sure power is disconnected from your Cintel scanner.
2 On the reader's upper adjustment knob, you'll find a small retention screw recessed
into one side. Use a 1.5mm Allen key to loosen this screw and slide the knob off its
spindle. This lets you remove the reader's upper cover.
Use a 1.5mm allen key to loosen the adjustment knob's retention
screw, then remove the knob from its spindle
3 Remove the upper and lower covers from the Audio and KeyKode Reader by
unscrewing the 6 x M3 screws with a 2.5mm Allen key. The screws are 'captive' so they
remain attached to the reader. Removing the covers gives you access to the captive
screws needed to attach the reader to your Cintel scanner.
Remove the upper and lower covers from the reader by unscrewing the six M3
cover screws. As they are captive screws, you only need to unscrew them a
short distance until they release contact, as shown in the image above. .
Optional Audio and KeyKode Reader 42