Running A Test - Adam Equipment PMB 53 Manual Del Operador

7.0 RUNNING A TEST

If necessary the user can set a new set of values for a test setting or recall a
pre-stored set of values. See section 6. The last used set of values are
stored so they are always shown initially, even after power has been turned
off. That way if the last test settings are still valid the user can immediately
use them.
The basic operation after test settings are set is as follows:
Place an empty sample pan on the analyzer.
Press [0/T / Esc] to zero the weight.
Fill the sample pan with the sample.
to prepare a sample.
Place the filled pan on the analyzer.
Lower the lid of the
start has been selected the test will begin after a 5 second delay or after the
test settings have been previewed.
If Manual start has been selected press the [Start] key.
The test will begin. If the test setting Preview has been enabled (See section
10.1.2) the display will show the current test settings one after the other. The
drying test begins immediately after the preview is completed. ..
If you need to abort the test before it begins press the [Start] or [0/T /
Esc] key to return to normal.
33
| P a g e
MASS 23
ºC
0.000
g
MASS 23
ºC
5.670
g
See Section 14 for assistance in how
weighing chamber, if automatic
© Adam Equipment Company 2017