Analyzer Recall Parameters; Request Values Of Parameters - Adam Equipment PMB 53 Manual Del Operador

When the analyzer receives a valid command, it will return the message E0.
But if an invalid input command is received, then the command is returned as
follows-
Message returned
E1
E2
E3
E4
E5
11.5.3

ANALYZER RECALL PARAMETERS

When parameters and results are saved in the memory. To recall all the
saved records, it is necessary to send a command as follows-
Recall result<cr><lf>
Recall config<cr><lf>
Recall preset<cr><lf>
The PMB will return the list of parameters or data stored in the analyzer menu.
The test results, test presets and analyzer configuration are all stored
separately.
To recall an individual parameter send the parameter name followed by a
question mark. For example sending heat=?<cr><lf> , the analyzer will send
back a message HEAT=1 for ramp heating applications.
11.5.4

REQUEST VALUES OF PARAMETERS

If the command for a parameter is sent with a "?" the PMB will send the value
currently stored in the analyzer. For example send:
Single temp=?<cr><lf>
Single Temp=115<cr><lf>
62
| P a g e
Remarks
The analyzer can not recognise this command.
String length is not right. i.e. key beeper=20<cr><if>
String exceeds range. i.e. key beeper=2<cr><if>
The string contains non-numeric character. i.e. key beeper=a
<cr><if>
You do not have the authority to use this commands.
the PMB will send back
Get all the test result
Get all the set up parameters
Get all the preset parameters
© Adam Equipment Company 2017