Levelling The Analyzer; Warm-Up Time - Adam Equipment PMB 53 Manual Del Operador

3.3

LEVELLING THE ANALYZER

3.4

WARM-UP TIME

Before you start weighing, you have to wait for the analyzer to achieve a
stable internal temperature.
material test to preheat the weighing chamber so that the delay to reach
operating temperature is minimised.
7
| P a g e
After placing the PMB in a suitable location, level
it by using the spirit level on the rear of the
analyzer. To level the PMB turn the two
adjustable feet at the rear of the analyzer until
the bubble in the spirit level is centred.
Attach the power supply cable to the connector
on the rear of the analyzer. The master power
switch is on the rear panel, next to the mains
cable. Turn the power on.
The display will indicate the serial number and
the software revision number followed by the
capacity. Next the analyzer will run a self-test
by displaying all segments. The display will then
show zero weight accompanied by the 0
symbol.
In addition it may be necessary for some
~
A stable sign
stable condition. It will turn off if the reading is
not stable.
Exact zero is shown when the "0 " symbol
is on to the left of the display area.
© Adam Equipment Company 2017
is shown when the PMB is in