Serial Interface; Rs-232 Hardware; Usb Serial Hardware - Adam Equipment PMB 53 Manual Del Operador

11.0 SERIAL INTERFACE

The PMB has the ability to send or receive data over the serial interface.
Using either the RS-232 or the USB serial interface.
The test data can be sent over the interface either automatically or when the
user presses the [Print/] key.
The user has control over what data is to be printed.

11.1 RS-232 HARDWARE

The RS-232 interface is a simple 3 wire connection. The input and output
connections are:
Connector:
Handshaking is not applied.
Baud rate:
Parity:
All lines are terminated with carriage return and line feed (<CR><LF>).
In continuous output mode, the serial output format will be a single line in the
form "12.567 g<CR><LF>".

11.2 USB SERIAL HARDWARE

The USB interface is a standard USB connection. To use the USB interface it
is necessary to plug the analyzer into the USB port of a PC.
The PC will recognise the new device and search for a suitable driver.
none are found a message will be displayed to guide the user through the
installation of suitable software.
56
| P a g e
9 pin D-sub miniature plug
Pin 2 Input to analyzer
Pin 3 Output from analyzer TXD
Pin 5 Signal ground
2400, 4800, 9600, 19200, 38400
NONE (=8N1), EVEN (=8E1) or ODD (=8 O 1)
RXD
GND
© Adam Equipment Company 2017
If