BlueMax Mini Modular Plus Manual De Instrucciones página 116

Start up / trial run
Switch for hold-down clamp / stroke reduction
Set switch for hold-down clamp to hole line
This will automatically release the hold-down clamps
after the drilling process which means there is no need to
release them manually. Swivel in swivelling lever for stroke
reduction. With the motor switched off, move the machine
to the drilling position and move lever inwards (hole line
pictogram can be seen)
en
Drilling with the continuation stop
(shown here with the right continuation stop)
Push workpiece up against centre stop
(start position of 1st hole in the hole line, for 19 mm panel
material = 10 mm)
Activate drilling process and move panel material to the right
until the pendulum of the continuation stops has slid over
the last drill hole. Now pull the panel material back until the
pendulum pin has engaged in the drill hole and is perfectly
vertical. Pull workpiece as far as the pendulum stop
116
.
3
.
4
5
6
3
4
5
.
6