Settings On The Back Of The Machine - BlueMax Mini Modular Plus Manual De Instrucciones

Referring to the scale, set the height on the horizontal
unit by turning star shaped grip on the horizontal drilling
unit.
Carry out a trial drilling to check these settings.
The horizontal drilling unit's stroke speed (drilling into
the workpiece) can be set by means of the adjustment
screw . End position damping (horizontal drilling unit
1
back to home position) by means of the adjustment screw
2.
Carry out a trial drilling to check these settings.
Always use the eccentric tensioner for drilling with the
horizontal drilling unit.
Take the eccentric tensioner from the parked position
and use it to tension the workpiece. To do this, use the
drill hole in the machine bench that is closest to the
workpiece. Position the eccentric tensioner here and turn
the white plastic panel towards the workpiece. Turn the
eccentric tensioner lever anticlockwise until it starts to
clamp the workpiece.
Initiate drilling stroke via hand button or foot switch.

Settings on the back of the machine

Shortly before the drill bits penetrate the workpiece, their
speed can be limited to obtain good drilling results. The
rate is reduced just before the drill bits reach the panel.
Lower end position damping is adjusted using setscrew
in the stroke cylinder at the rear of the machine. Drilling
penetration rate can be reduced or increased by turning
the adjustment screw.
Adjustment screw in the valve is used for setting the
2
length of time the hold-down clamps remain in position
after drilling (drilling hole lines only).
Adjustment screw adjusts downward drilling rate.
3
The time for which the vertical drilling units continue
to run can be set via the adjustment screw
materials, the drilling unit must run longer for the drill
bits to remove the cuttings from the drill hole. Carry out
a trial drilling to check the setting.
WARNING
Warning - Hand injuries!
Be careful when setting the continued running
time, do not reach into the rotating drill bits!!!
2
1
1
2
. For MDF
4
4
3
1
en
131