Setting up
Limiting drilling stroke for drilling hole lines
To work more effectively, the drilling stroke can be
shortened for drilling hole lines. Before setting, please
deactivate the motor switch to prevent the drill bits from
rotating.
Start drilling stroke via hand button or foot switch.
Keep the hand button / foot switch pressed until the
interchangeable drilling unit reaches the lowest end
position. Now turn stop using lever
A short stroke is carried out for the next work cycle.
WARNING
Warning - Hand injuries!
Exercise care when the drilling unit moves up and
down, there is a danger of crushing!
NOTE
Check all settings once you have finished making
them.
en
3. Hold-down clamp and centre stop
Hold-down clamp
Depending on panel thickness, hold-down clamps must
be vertically adjusted. Workpiece and hold-down clamp
foot
must be spaced apart by no more than 6 mm
3
(if necessary, place an A/F 5 mm Allen key spanner
underneath). To set spacing, undo clamping screw
re-position hold-down clamp
clamping screw once correct height is achieved.
WARNING
Warning - Hand injuries!
Before attempting any servicing and setting work,
disconnect the machine from the power supply
and shut down the compressed air. Prevent the
machine switching back on again unexpectedly.
Hold-down clamp
1
ensure workpiece is securely clamped in place for drilling.
Undo the clamping levers
clamp. The hold-down clamps can be adjusted further
by releasing the clamping levers
levers after positioning.
WARNING
Warning - Hand injuries!
Do not move the arm under the drilling head.
132
.
2
in its retainer. Tighten
1
must be moved into position to
/
to set the hold-down
4
5
. Re-tighten clamping
5
2
1
2
and
2
3
4
1
5
1
max. 6 mm