Setting Up; Preparing Machine; Readiness For Use; Connecting To Extractor System - BlueMax Mini Modular Plus Manual De Instrucciones

Setting up

7. Setting up
1. Preparing machine
Readiness for use
Connecting to extractor system
Connecting to compressed air supply
Connecting to power supply
Switching on
Operating
Drilling hole line, interchangeable drilling unit,
9 spindles
Inserting hinges
2. Setting up (preparing for work)
Tools used (drill bits)
Interchangeable drilling unit, 6 spindles,
Interchangeable drilling unit, 3 spindles (Selekta 22/9) 127
en Interchangeable drilling unit, 9 spindles
Interchangeable drilling unit, 90°, 9 spindles
Changing interchangeable drilling units
Cleaning
Fitting drilling units
Checking switch for proper working order
Setting drilling depth, vertical drilling unit
Drilling with horizontal drilling unit
Settings on the back of the machine
Limiting drilling stroke for drilling hole lines
3. Hold-down clamp and centre stop
Hold-down clamp
Centre stop
Setting the drum stops
Pendulum stops
122

1. Preparing machine

The BlueMax Mini Modular Plus is shipped in cardboard
packaging. A number of parts and components must be
122
installed to make the machine ready for operation. Once
assembled, the machine must be thoroughly cleaned
122
(removal of dust and any oil or grease)
122
Before switching the automatic drilling and insertion
123
machine on, satisfy yourself that
123
• any installation, set up and servicing work has been
completed in full
124
• no persons are present in the danger zone, let alone
124
working on it
• all safety guards are fitted in the prescribed way
125
• the compressed air supply is ready for operation
126
Before commencing production:
126
• Make sure the machine is safe and in proper working order
126
before and after you switch it on
• Make sure the compressed air supply is ready for operation
• Make sure the machine has been set up for the relevant
127
product
128
128

Readiness for use

128
The machine is ready for operation if
129
• all of the above stated activation processes have been
129
carried out,
130
• a trial run has been carried out,
130
• the compressed air supply is activated,
131
• the machine is set up for the relevant product,
132
• the machine is firmly mounted on a bench / base frame.
132
Production can now commence.
132
133

Connecting to extractor system

133
Connect the machine to an extractor system. It is compulsory
to use flexible, fire-retardant hose for connection to an
133
extractor system.
Fit the extractor system's extraction hose to suction
connector and secure this in place with a hose clamp.
1
The extractor system must have an airflow rate
of at least 20 m/s.
Extraction hose diameter: Ø 80 mm. Route extraction hose
so as not to exert strain on the suction connector!
1
Fig. 21: Suction extraction connector