Installing Support Block - BlueMax Mini Modular Plus Manual De Instrucciones

5. Screw laser holder into place
6. Screw on blank in control console and
thread in cable
7. Insert cable ties into holders
8. Push plastic tubing onto cable, plug in plug
in control console, close control console,
close cable ties
9. Fit laser and connect cable
10. Connect laser and aim at workpiece edge
and scale

4. Installing support block

The support blocks are screwed into the base profile at the
left and right side by means of a clamping stone. First insert
the sliding block into the profile and move to the required
position. Then screw the support block into the sliding block
using the hexagon socket screws.
en
167