Drilling Hole Line, Interchangeable Drilling Unit, 9 Spindles - BlueMax Mini Modular Plus Manual De Instrucciones

Drilling hole line, interchangeable drilling unit, 9 spindles

Continuation stops
The continuation stops are premounted on the
Interchangeable drilling unit, 9 spindles.
Setting template for setting continuation stops
Setting height of the continuation stop
The height of the left and right continuation shop must be
adjusted to suit the panel thickness by means of top setting
ring . The continuation stop's finger should engage as
1
deeply as possible into the drill hole. A space of approx.
3 mm must also be allowed between workpiece and stop
(insert a 3 mm hexagon socket spanner
Switch for hold-down clamp / stroke reduction
Set switch for hold-down clamp to hole line
automatically release the hold-down clamps after the drilling
process which means there is no need to release them
manually. Swivel in swivelling lever for stroke reduction. With
the motor switched off, move the machine to the drilling
position and move lever inwards (hole line pictogram can be
seen) .
4
Drilling with the continuation stop
(shown here with the right continuation stop)
Push workpiece up against centre stop
1st hole in the hole line, for 19 mm panel material = 10 mm)
Activate drilling process and move panel material to the right
until the pendulum of the continuation stops has slid over
the last drill hole. Now pull the panel material back until the
pendulum pin has engaged in the drill hole and is perfectly
vertical. Pull workpiece as far as the pendulum stop
Restart drilling process and check distance between last
drilling of 1st drilling process and 1st drilling of second
drilling process .
7
The distance can be checked best by inserting two 5 mm
pins into the drillings. For this, you must use a calliper
and measure from the outer edge of the pins
produce a dimension of 37 mm (32 mm distance between the
drillings + 2 times 2.5 mm = 37 mm)
If the dimension differs from 37 mm, the continuation stop
must be readjusted.
For this, undo the screw at the pendulum and tighten or
slacken the grub screw using a hexagon socket spanner
(1 turn = 0.8mm)
9.
)
2
. This will
3
(start position of
5
.
6
. This must
8
9
1
2
3
4
6
7
8
5
125 125
en