Fitting Drilling Units; Checking Switch For Proper Working Order - BlueMax Mini Modular Plus Manual De Instrucciones

Clean guide pins .
1
Hole in guide pin must be clean so clamping screw can
2
hold interchangeable drilling unit securely in place.
Fitting drilling unit
Fit the prepared interchangeable drilling unit by holding
the grip or by placing your hand below yoke
Make sure guide pin goes in straight.
Move interchangeable drilling unit up and engage safety
catch .
1
Tighten star shaped grips .
3

Checking switch for proper working order

The 6 spindle interchangeable drilling unit is used for
drilling holes and for inserting a hinge / connector.
The drilling unit's drive system must be switched off for
inserting the hinge / connector.
Using the hand lever , turn press-in frame
2
inserting position. Operate switch
turn motor off using the switch. Check for proper working
order. Adjust the switch if necessary.
Switch must always be checked for proper working
1
order after changing the drilling unit or after the machine
has been out of service for a prolonged period.
1
2
1
.
2
2
3
1
into the
2
with the lever and
1
en
129