Allmand NIGHT-LITE V Serie Manual Del Operario página 18

Operating the Outriggers
The unit is equipped with left and right outriggers at the
rear of the machine.
WARNING
Rollover Hazard
• Failure to deploy the outriggers before raising the
light tower could cause the light tower trailer to tip
over, resulting in death or serious injury. Always
deploy the outriggers before raising the light tower.
• Failure to lock the stabilizer jack in the operating
position could cause the back of the light tower trailer
to fall, resulting in death or serious injury. Always
be sure to lock the stabilizer jack in the operating
position with the jack locking pin.
• Stabilizer jacks must be supported by a flat, level
solid ground surface.
To deploy the outriggers:
1. Lift the outrigger locking pin (A, Figure 14).
2. Slide the outrigger (B, Figure 14) out until the pin
locks the outrigger in the operating position.
Note: When initially shipped from the factory, the
outrigger jacks are positioned toward the front of
the machine (not shown) for shipping purposes.
They should be repositioned toward the rear of the
machine as shown in Figure 14. To reposition, slide
the outrigger completely out, rotate the outrigger so
the jack is positioned toward the rear of the machine,
and reinstall, making sure the pin locks the outrigger
in the operating position.
3. Remove the stabilizer jack locking pin (C, Figure
14), rotate the jack into the operating position (D,
Figure 14), and install the stabilizer jack locking pin
fully through the top and bottom holes in the jack and
outrigger.
4. Unfold the handle (E, Figure 15) of the stabilizer jack,
then turn clockwise (F, Figure 15) to lower the jack
foot (G, Figure 15) until firmly planted on the work site
surface.
5. Repeat for the opposite outrigger and stabilizer jack.
To retract the outriggers:
1. Fully raise the stabilizer jack foot by turning the jack
handle counterclockwise.
2. Fold the handle.
3. Remove the stabilizer jack locking pin, rotate the jack
into the transport position, and install the stabilizer
jack locking pin fully through the top and bottom holes
in the jack and outrigger.
4. Lift the outrigger locking pin, and slide the outrigger
in until the pin locks the outrigger in the transport
position.
5. Repeat for the opposite stabilizer jack and outrigger.
18
14
A
B
15
Fueling the Unit
WARNING
Fire Hazard
Adding fuel to the light tower trailer with the engine
running could cause a fire resulting in death or serious
injury. Always make sure that the engine is shut down
before adding fuel to the fuel tank.
The light tower trailer is equipped with a single fuel tank
having a capacity of 45 gallons (170 L).
C
D
F
E
G
www.allmand.com