Publicidad
Idiomas disponibles
Idiomas disponibles
3. Lower the light tower. See Raising And Lowering
the Light Tower.
4. Rotate the light tower to the transport position. See
Adjusting the Lights.
5. Adjust the light fixtures to the transport position. See
Adjusting the Lights.
6. Make sure the engine compartment cover is closed
and latched.
7. Make sure the fuel door, radiator door and control
panel door are closed and secured.
8. Retract the outriggers. See Leveling and Stabilizing
the Light Tower Trailer.
9. The unit is now ready for transport. See
Transporting the Light Tower Trailer.
Maintenance
WARNING
Operating or towing a machine with worn, damaged
or missing parts could result in death or serious injury.
Replace worn, damaged or missing parts immediately. Do
not operate or tow this machine until all worn, damaged
or missing parts have been replaced, and the machine
operates correctly.
WARNING
Performing maintenance on equipment that is capable of
being inadvertently started could result in death or serious
injury. Always disconnect the black negative (-) battery
cable before servicing equipment.
Before performing any maintenance procedures, read
Safety.
Proper maintenance and care of the equipment is a
must for safe and reliable operation. Use the following
maintenance and care guidelines in addition to those
scheduled by your shop equipment maintenance
schedule.
Where equipment is operated under severe conditions
(very dusty, extreme heat or cold, etc.), affected items
should be serviced more frequently.
Engine
For engine service intervals and other recommendations
specific to this light tower unit refer to Specifications.
Refer to the Engine Operator's Manual for all other
scheduled engine maintenance procedures.
Engine Oil Drain
The unit is equipped with a remote engine oil drain (A,
Figure 26), located on the right side of the light tower
trailer toward the rear. To drain the engine oil:
1. Place an approved container beneath the oil drain.
2. Remove the oil drain plug.
24
3. Open the oil drain valve, located on the engine oil
pan (B, Figure 26, inset).
4. Allow the engine oil to drain completely into the
approved container. Be sure to dispose of used
engine oil according to local, state, province and/or
federal rules.
5. Close the oil drain valve.
6. Replace the oil drain plug, tightening securely.
7. Change oil filter as needed. Refer to Specifications.
8. Add oil to the engine. Refer to Specifications.
26
A
B
Engine Coolant Drain
NOTICE
Failure to use the required coolant type (as stated in
the Specifications section) in the radiator may result
in damage to the engine and radiator, thus voiding the
warranty.
NOTICE
The mixing of different coolant types in the radiator may
result in damage to the engine and radiator, thus voiding
the warranty.
The unit is equipped with an engine coolant drain valve
(A, Figure 27). To drain the engine coolant:
1. Attach a 3/8" ID hose to the coolant drain valve, and
route the hose to empty into an approved container.
2. Open the coolant drain valve.
3. Let the engine coolant drain fully into the approved
container. Dispose of used engine coolant according
to local, state, province and/or federal rules.
www.allmand.com
Publicidad
