Allmand NIGHT-LITE V Serie Manual Del Operario página 22

4. Tighten the light tower locking knob.
5. When lighting operations are complete, rotate the
light tower to the transport position: Align the light
tower tab (C, Figure 21) with the front center of the
light tower base. Be sure to tighten the light tower
locking knob securely.
21
Raising and Lowering the Light Tower
The unit may be equipped with a standard manual winch
or an optional electric winch to raise and lower the light
tower.
DANGER
Electrocution Hazard
Raising the light tower in the presence of electrical
power lines will result in death or serious injury. Always
check overhead wires and obstructions before raising or
lowering the light tower.
WARNING
Rollover Hazard
Before raising, lowering or operating the tower lights,
the trailer must be set up, leveled and stabilized. See
Leveling and Stabilizing the Light Tower.
WARNING
Crush Hazard
Standing under the light tower while raising or lowering
could result in death or serious injury. Make sure that
there are no persons near the light tower when raising or
lowering the light tower.
22
B
C
A
Raising the Light Tower - Manual Winch (Standard)
1. Shut down the engine. See Operating the Engine.
Wait 10 minutes for the lights to cool.
2. Before raising the light tower, adjust the tower lights
to the desired work position. See Adjusting the
Lights.
3. Turn the winch handle (A, Figure 22) clockwise
(B, Figure 22) until the tower is fully raised. Do not
overturn the handle.
Lowering the Light Tower - Manual Winch (Standard)
1. Shut down the engine. See Operating the Engine.
Wait 10 minutes for the lights to cool.
2. Turn the winch handle counterclockwise (C, Figure
22) until the tower is fully lowered. Do not overturn
the handle.
22
B
C
Raising the Light Tower - Electric Winch (Optional)
1. Shut down the engine. See Operating the Engine.
Wait 10 minutes for the lights to cool.
2. Before raising the light tower, adjust the tower lights
to the desired work position. See Adjusting the
Lights.
3. Open the control panel door. Move the tower raise
switch up (A, Figure 23, on the right side of the
control panel) until the tower is fully raised.
Note: The ignition switch must be turned to the RUN
position (B, Figure 23) to operate the tower raise
switch.
Lowering the Light Tower - Electric Winch (Optional)
1. Shut down the engine. See Operating the Engine.
Wait 10 minutes for the lights to cool.
2. Move the tower raise switch down (C, Figure 23) until
the tower is fully lowered.
Note: The ignition switch must be turned to the RUN
position to operate the tower raise switch.
A
www.allmand.com