Publicidad
Idiomas disponibles
Idiomas disponibles
Trailer Wheels and Tires
WARNING
Towing Hazard
Towing the light tower trailer with damaged tires, rims or
lug nuts could result in death or serious injury. Repair or
replace damaged tires, rims or lug nuts before towing the
light tower trailer.
1. Check the tires for any cracks, cuts or damage.
Repair or replace as needed.
2. Check the tire pressure of the trailer tires when cold.
See Specifications.
3. Check the wheel rims for any cracks or damage.
Repair or replace as needed.
4. Make sure all the lug nuts are in place and properly
tightened. Correct torque for the lug nuts is 90 lb-ft
(122 Nm).
Servicing the Axle
The axle under the light tower trailer will require periodic
maintenance and service. Such things as wheel bearing
adjustment and repacking will be required to maintain
the axle. For information on the maintenance schedule
and servicing the axle, see the axle owner's manual at
https://www.dexteraxle.com/resources/manuals.
Trailer Lighting
WARNING
Towing Hazard
Towing the light tower trailer with inoperable trailer lights
could result in death or serious injury. Repair or replace
inoperable trailer lights.
Trailer lights are a safety feature, and are required by law.
Keep the trailer lights in proper working order.
•
Check the trailer lights and wiring for damage or
wear. Repair or replace as needed.
•
Check to be sure the wiring harness is secured to the
trailer and does not hang down to the ground.
•
Check the trailer light housing assemblies for damage
or leaks. Use silicone or rubber sealant to seal the
lens or harness, as needed, or replace the housing
assembly. Electrical grease will help protect the
sockets and prevent corrosion.
•
When replacing bulbs, be sure to use the correct
replacement bulb. A small amount of electrical grease
in the sockets will prevent corrosion.
For trailer wiring schematic information, refer to the
separate Wire Schematic Manual.
28
Maintaining the Battery
WARNING
Explosion, Burn, and Shock Hazard
Batteries give off explosive gases during recharging.
Sparks could cause explosions, resulting in death or
serious injury.
Batteries contain acid, which is extremely caustic.
Contact with battery contents could cause severe
chemical burns.
Batteries present a risk of electric shock and high short
circuit current.
•
Always disconnect the negative (-) battery cable
before servicing equipment.
•
DO NOT dispose of battery in a fire. Recycle battery.
•
DO NOT allow any open flame, spark, heat, or
lit cigarette during and for several minutes after
charging a battery.
•
DO NOT open or mutilate battery.
•
DO NOT charge a frozen battery. Always slowly warm
the battery to room temperature before charging.
•
Wear protective gloves, rubber apron, rubber boots
and rubber gloves.
•
Remove watches, rings, or other metal objects.
•
Use tools having insulated handles.
Removing and Installing the Battery
To remove the battery
WARNING
Explosion Hazard
Failure to remove the black negative (-) battery cable(s)
first could cause sparks and/or an explosion resulting in
death or serious injury. Always remove the black negative
(-) battery cable(s) first.
1. Unlatch and open the engine compartment cover.
2. Disconnect the black negative (-) cable (A, Figure
30) from the negative (-) battery terminal, and secure
away from the battery.
3. Disconnect the red positive (+) battery cable (B,
Figure 30) from the postive (+) battery terminal, and
secure away from the battery.
4. Loosen the hardware securing the battery hold-down
(C, Figure 30), and remove the hold-down.
5. Carefully remove the battery, and place in a well-
ventilated area on a level surface.
www.allmand.com
Publicidad
