Publicidad
Idiomas disponibles
Idiomas disponibles
To install the battery
WARNING
Explosion Hazard
Failure to install the black negative (-) battery cable(s)
last could cause sparks and/or an explosion resulting in
death or serious injury. Always install the black negative
(-) battery cable(s) last.
1. Carefully place the battery in the engine compartment
with the battery terminals toward the front of the unit.
2. Install the battery hold-down on top of the battery.
Tighten the hardware securely.
3. Connect the red positive (+) battery cable(s) to the
positive (+) battery terminal.
4. Connect the black negative (-) battery cable(s) to the
negative (-) battery terminal.
5. Replace the terminal covers over the battery
terminals.
6. Close and latch the engine compartment cover.
30
Cleaning
WARNING
Entanglement / Sever Hazard
Failure to shut down the engine before cleaning the unit
could result in death or serious injury. Always shut down
the engine before cleaning the unit.
WARNING
Burn Hazard
Shut down the engine and let components cool before
cleaning the unit. Failure to do so could result in serious
burns.
B
A
C
NOTICE
Use caution when using compressed air or water / steam
pressure washers. Do not pressure–clean electrical
components, as this may cause damage.
Keeping the light tower clean is important to ensure
proper operation. Dirt and dust buildup acts as an
insulator and may cause the engine, generator and light
assemblies to operate at excessively high temperatures.
Use the following as cleaning guidelines:
1. Clean the light tower trailer to remove all dust, dirt or
other foreign material.
2. Clean the light tower and light fixture assemblies with
a damp cloth or sponge.
3. Clean all electrical wiring and components by hand
using non-corrosive cleaner.
4. Clean the inside of the engine compartment.
5. Clean any oil or liquid spills inside the engine
compartment.
6. Empty the fluid containment tray (if equipped). See
Drain the Fluid Containment System (FCS).
Models and Serial Numbers
Model and serial number information is required for
product support and repair parts. Following are the model
and serial number locations of the primary components.
Trailer
The serial number plate for the light tower trailer is
located on the left side of the unit above the front forklift
pocket (A, Figure 31).
31
A
Marathon Generator
The generator has a serial number plate (A, Figure 32)
attached to the front of the housing.
en
29
English
Publicidad
