Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Description
3.5
Control panel/control elements
ELEMENT
FuNCTION
LED
LED flashes in ready-to-weld state.
LED lights up constantly during the welding process.
Starts the welding process.
START
When the START/STOP key is operated during the welding process, this is stopped
STOP
and the gas post purge time is started.
If the START/STOP key is pressed once more during the gas post purge time, the gas
post purge time and the cooling liquid flow are interrupted.
ROTATION
Pressing briefly: Rotor rotates step-by-step (clockwise) in the welding direction.
Pressing and holding: Rotor rotates continuously (clockwise) in the welding direction.
WIRE FEED
Pressing briefly: Wire is transported step-by-step (in feed direction).
(function only for
KD versions)
Pressing and holding: Wire is transported continuously (in feed direction).
WIRE RETuRN
Pressing briefly: Wire is transported step-by-step (against the feed direction).
(function only for
KD versions)
Pressing and holding: Wire is transported continuously (against the feed direction).
74
ORBITALuM TOOLS GmbH D-78224 Singen www.orbitalum.com
ORBIWELD TP 400, TP 600
[REV. 20231027] OW_ORBIWELD_TP_BA_812060201_01__INH-01_EN
ORBIWELD TP 400, TP 600
3.6
Remote control (optionally available)
The ORBIMAT remote control is an external remote control for controlling open welding tongs:
• Matching for all ORBIWELD TP welding tongs.
Mandatory for the usage of ORBIWELD TP welding tongs: with AVC/OSC.
• Suitable for all ORBIMAT welding power supplies (the remote control is already included in the scope of delivery with the
ORBIMAT 300 CA AVC/OSC).
This chapter only describes the basic functions of the remote control. The more advanced function and application descriptions
are described in the separate operating instructions of the remote control.
13
12
11
10
9
ITEM
DESIGNATION
FuNCTION
1
EMERGENCY-STOP switch
Pressing: The power source is disconnected from the mains voltage.
2
Status-LED
LED lit up: Power source is switched on.
3
Start key with LED
LED flashes in ready-to-weld state.
LED lights up constantly during the welding process.
Starts the welding process.
4
STOP key
5
Start key with LED
Pressing: Gas and cooling liquid flow is started/stopped.
6
Key for slope off
Pressing: Welding process is aborted and the slope off is started.
[REV. 20231027] OW_ORBIWELD_TP_BA_812060201_01__INH-01_EN
ENGLISH
Description
1
2
3
4
5
6
7
8
75
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
Publicidad
