Angelo Po BX61E Manual De Uso página 48

ENGLISH
IMPORTANTE: To guarantee functionality
over time, to prevent bacterial proliferation in the
chamber and to improve prevention of possible
corrosion, perform at least one wash cycle a day .
IMPORTANTE: Whenever the cooking
mode is changed, clean the chamber thoroughly .
To carry out this operation, proceed as follows.
1) In STOP status press button (16) once; the green
light of button (2) comes constantly on. The display
(11) shows the message CLE, the display (12) the
message Pr and the display (13) the message P01.
2) Press the button (2), the green light of button
(2) starts to flash and the display (11) shows the
message CLE and the display (12) the message
25' (total washing time).
3) When the beeper sounds and the CLE message
flashes on the display, place the detergent in the
cooking chamber.
4) Open the door and spray the food-approved detergent onto all the walls of the cooking chamber, the
heat exchanger and the fan.
Use of the "cleaner spray" accessory and the detergent provided by the manufacturer is recom-
mended for this procedure .
ATTENTION: When cleaning and sanitising the appliance with detergents, wear personal
protection equipment (gloves, masks, goggles, etc .) as required by the relevant health and safety
legislation .
5) Close the door and wait for the oven to complete the washing, rinsing and final thermal disinfection
program automatically. A beeper sounds at the end of the washing cycle.
IMPORTANT: Before cooking again, check that no detergent residues have been left in the
cooking chamber . If residues are found, rinse the cooking chamber thoroughly and heat the oven
in "convection" mode for about 15 min . to dry it out .
IMPORTANT: To guarantee functionality over time and to improve prevention of possible
corrosion, descaling must be carried out .
If the text "dEC" appears on the display (11) it means that the following cleaning operations must be
carried out:
1) In STOP status press button (16) once to select "washing"; the green light of button (2) comes con-
stantly on. The display (11) shows the message CLE, the display (12) the message Pr and the display
(13) the message P01.
2) Press the key (2), the green light of key (2) starts to flash and the display (11) shows the message CLE
and the display (12) the message 25' (total washing time).
3) When the buzzer goes off and the message CLE flashes on the display, introduce the descaler in the
cooking chamber.
4) Open the door and spray the DESCALER, with pH<7, on all the walls of the cooking chamber, on the
heat exchanger and on the fan.
It is recommended to use the "spray" accessory and the DESCALER for this operation .
ATTENTION: When cleaning and sanitising the appliance with detergents, wear personal
protection equipment (gloves, masks, goggles, etc .) as required by the relevant health and safety
legislation .
5) Close the door and wait for the oven to complete the washing, rinsing and final thermal disinfection
program automatically. A beeper sounds at the end of the washing cycle.
IMPORTANT: Check that the cooking chamber has no leftover descaler before cooking
again . Otherwise thoroughly rinse the cooking chamber and activate heating in "convection"
mode for about 15 min . to dry it .
20
WASHING APPLIANCE
11
WARNING FOR DESCALING
USE AND OPERATION
REAL
INJ
2
12
13
16
3326461_GB_rev.1