Publicidad
Idiomas disponibles
Idiomas disponibles
FAULT
The appliance has been tested before being put into service.
The information provided below is intended to assist in the identification and correction of any anoma-
lies and malfunctions which might occur during use.
The user can solve some of these problems himself, but for others specific technical knowledge or skill
is required, and so they must only be carried out by qualified staff with recognised experience acquired
in the specific sector of operation.
NOTE: For all requirements contact the agents or the headquarters of Angelo Po which can
be found in the contacts section of the website http://www .angelopo .com .
Fault
The appliance does not switch
on
Cooking cycle does not start or
stops suddenly
If the problem or fault noticed is not amongst those
listed in the table, consult the "Key to Alarms" table
provided below.
The information provided below s intended to identi-
fy the alarm signals which appear on the display (11).
NOTE: Press button (14) to reset the alarm
and the cooking cycle restarts automatically; if
this is not the case, press the start key (2) .
3326461_GB_rev.1
FAULT
TROUBLESHOOTING
Cause
Fuse "blown".
Safety or protection device (safe-
ty thermostat or overload cutout)
tripped.
Electronic circuit board damaged. Contact the after-sales service.
Control board electronic circuit
board damaged.
Alarm triggered.
TABLE OF ALARM INDICATIONS
Remedy
Replace the fuse (see installation
manual).
Press device reset button.
Contact the after-sales service.
Consult the "Key to Alarms" table.
11
REAL
INJ
14
ENGLISH
2
25
Publicidad
